Input Jacks - YORKVILLE elite E10P Manuel D'utilisateur

E10P Powered Speaker
Power, superb sound quality, compactness,
durable reliability and amazing versatility are
at your fingertips. The E10P is an advanced,
compact two-way powered speaker designed
for a wide variety of pro-audio applications.
Innovative processing is built-in to ensure
optimum performance and clarity, including the
ability to electronically reduce feedback. The
lightweight, low-noise 300-Watt Class-D ampli-
fier for the woofer is complemented by a two-
tier 50-Watt amplifier for the horn (providing
exceptionally clear and linear high-frequency
response). An active crossover for the ampli-
fiers ensures that the woofer and horn operate
optimally; meanwhile, separate non-defeatable
limiters protect those drivers from excessive
peaks and over-powering. The drivers them-
selves are from one of the world's premier
manufacturers offering an extended lifetime of
smooth, powerful performance.
Versatility is the E10P
By designing the cabinet with an angled side
and a stand adapter we made it possible for
the E10P to be used either as part of your main system or as a stage monitor. For even more versatility, the
E10P converts from a main/monitor system to a micro-PA. At the touch of a button it becomes capable of
directly accepting a dynamic microphone. The 3-stage anti-feedback feature and bass/treble EQ make both
system and micro-PA usage even more convenient. For use with a powered subwoofer, simply push another
button on the E10P and all frequencies below 100 Hz are rolled off steeply. Result – no need for a crossover.
We are confident you will find the E10P a worthy mainstay for sound applications of all types and sizes.
The following section will help you to realize the E10P's full capabilities.
1. Power Switch and Indicator
The green power LED illuminates when the power switch is turned to the On posi-
tion and AC voltage is supplied.

2. Input Jacks

This female-XLR / ¼-inch TRS combi-jack accepts either microphone or ¼-inch TRS
patch cables. For best noise reduction, use balanced cables, however unbalanced
¼-inch TS cables can be used for unbalanced signal sources. Alternatively, a dynamic
microphone can be directly connected here.
3. Link
This XLR male connector can be used with a standard XLR cable ( XLR micro-
phone cable for interconnecting E10Ps in a multi-speaker system. In Line Mode,
(see Mic/Line Pushbutton below) up to ten (10) E10Ps can be interconnected
without signal degradation.
Note: Both ¼-inch and XLR inputs have identical functionality.
Note: While it is possible to link E10Ps in Mic mode, it is recommended to use
Line mode for best, noise-free performance. The number of E10Ps that can be
linked in Mic mode depends on the degree of electrical interference present in
the area and on the AC wiring.
1