Duress User Code; Setting The Duress User Code; Secret Duress Button - 2GIG Go!Control Mode D'emploi

Duress User Code

The Duress User Code (User Code #8) performs a special function. Controlling the system with this
code gives the appearance of normal operation, but using it secretly sends a "duress" report to the
Central Monitoring Station to initiate a silent alarm call for help.
USE THIS CODE ONLY IF SOMEONE IS FORCING YOU TO OPERATE YOUR SECURITY
SYSTEM AGAINST YOUR WILL. A silent report will be sent to the Central Monitoring Station and
they will dispatch help.

Setting the Duress User Code

1. On the User Management Screen,
press the USER 8 (DURESS) button.
2. A confi rmation screen will display;
press CREATE DURESS USER.
3. Enter a four-digit code for the new
Duress User Code and press OK.
4. Enter the Code again to confi rm
the code and press OK.
5. A confi rmation screen will
display; press OK.
6. The User 8 edit screen will display.
Press BACK to return to the
User Management Screen.

Secret Duress Button

On the Home Screen, in the lower right corner,
the system logo is displayed. The system logo
is the secret duress button.
With the system armed, pressing the logo will
display the standard disarm code entry screen.
Use a valid User Code or a Duress User Code
to disarm the system. The system will disarm
normally, but a silent duress report will be sent
to the Central Monitoring Station and they will
dispatch help.
The secret duress button can also be used
while the system is disarmed. Pressing the
logo will display a code entry screen. Enter the
Duress User Code and a silent duress report
will be sent to the Central Monitoring Station
and they will dispatch help. The system will
remain disarmed.
System Toolbox
Select User 8 for Duress User Code
Duress User Create Confi rmation Screen
Duress User Created Confi rmation Screen
Secret Duress
Button
Secret Duress Button
33