VTech Crystal Sounds Mode D'emploi page 13

Battery operation
1. The baby unit runs on  pcs 1.5V AA (AM-3/LR6) batteries (not
included). Please use alkaline batteries for best performance.
2. Do NOT use rechargeable batteries, as the baby unit does not
have a charging function.
3. Place  pcs 1.5V AA (AM-3/LR6) batteries
into the baby unit's battery compartment,
noting the + and - configuration. Replace the
battery compartment cover. The power-on
light will glow. The baby unit is ready for use.
. Note the + and – configuration inside the
battery compartment for using alkaline batteries.
Battery level indication
1. Battery light will flash when the baby unit's
battery power is low.
2. The light will be off when the baby unit
batteries have sufficient charge or it is plugged in
to an electrical outlet.
• Parent Unit
Rechargeable battery operation
1. The parent unit runs on 2 x AAA, 1.2V, 750mAh,
Ni-MH rechargeable batteries.
2. Charge the parent unit before you use it for the first time or
when the battery light indicates that the battery is low (the battery
light glows). The parent unit indicates that the battery power is
low 30 minutes before the battery power is completely empty.
3. To charge the parent unit, insert the small
appliance plug into the parent unit, then plug
the adaptor into a wall socket. The battery light
flashes while charging.
. When the batteries in the parent unit are fully charged, the low
battery light goes off. The parent unit is ready for use.
ON
Low
battery
ON
Full
battery
11