Warning Label Identification; Lubrication - Ingersoll Rand 7803R Instructions

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.

LUBRICATION

Ingersoll- - Rand No. 50
Always use of an air line lubricator with these tools.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
For International- - No. C28- - C4- - FKG0
For USA- - No. C28- - 04- - FKG0- - 28
Before starting the tool and after each eight hours of
operation, unless the air line lubricator is used, pour
approximately 1.5 cc of Ingersoll- - Rand No. 50 Oil into
the air inlet.
Model Type of Handle
7803R, 7803R- - EU reversible, pistol
Tested in accordance with ANSI S5.1- - 1971 at free speed
H
♦ Tested in accordance to ISO8662- - 1 at 80% rated free speed
ISO3744
•
All manuals and user guides at all-guides.com

WARNING LABEL IDENTIFICATION

Do not carry the tool by the
hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pres-
sure.
PLACING TOOL IN SERVICE
Ingersoll- - Rand No. 28
SPECIFICATIONS
Free Speed
rpm
400
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
WARNING
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Chuck Capacity
in (mm) Pressure
1/2 (13) 92.9
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905- -1)
HSound Level
♦Vibrations
dB (A) Level
m/s
•Power
105.9 0.4
2