Preparation Of The Appliance; Handling The Packed Appliance; How To Unpack The Appliance; How To Transport The Appliance - bluematic CUBE PLUS Manuel D'utilisation Et D'entretien

Since the packaging elements (plastic bags, staples, etc.) are a
potential source of danger, they should not be left within the reach
of children, disabled persons, etc. The gross weight of the appliance,
including packaging, is 11 kg.
The dimensions of the package are as follows (Fig.1):
The procedure for removing the device from its packaging is the
following:
1. Open the outer box.
2. Remove the accessories from the box and carefully lay them on
the ground.
3. Take out the vacuum head carton.
4. Take out the appliance from the box using the handle (1) (Fig.2),
being careful not to damage either during the operation.
5. Take out the appliance from the protective bag using the relative
The procedure for the safe handling of the device is the following:
1. Take all necessary steps to ensure that the device is in a safe
condition (see "MACHINE SAFETY
2. Remove the vacuum hose (1) from the vacuum nozzle (2) on the
collection tank, before pulling the vacuum hose press the button
(3) for unlocking the catch (Fig.3).
3. Insert the appliance into the protective bag, taking care not to
damage either during this operation.
4. Insert the appliance into the carton, taking care not to damage
either during this operation.
Remember to place at the bottom of the carton the block for the
wheels of the appliance, position around the collection tank the
blocks for preventing damage during transportation.
5. Insert the accessories support and the head block inside the
List of components
(Fig. 4-5-6-7-8-9):
1. Opening / locking motor head
2. Handle
3. Carry storage case for accessories and cable handle
4. Switch including power regulator
5. Slot for accessories
6. Cover for engine access
7. Container
8. Cable strain relief
9. Power cable
10. Tube and brush fixing seat
The stages for making the appliance safe, thereby making it possible
to carry out operations safely, are as follows:
1. Make sure that the main switch (1) is in the rest position, if not,
disable it by pushing it (Fig.10).
2. Check that the plug (2) on the power cable (3) has been taken
out of the socket (4) of the mains supply, and if not, disconnect
it (Fig.10).
3. Wind the power cable under the appliance's lifting handle.

PREPARATION OF THE APPLIANCE

HANDLING THE PACKED APPLIANCE

HOW TO UNPACK THE APPLIANCE

HOW TO TRANSPORT THE APPLIANCE

").

COMPONENT POSITIONING

APPLIANCE SAFETY
22
A: 415 mm
B: 465 mm
C: 485 mm
handle, taking care not to damage either.
ATTENTION: it is recommended that all the packaging
components be kept for any future transportation of the
appliance.
ATTENTION: Users are advised to always wear protective
gloves, to avoid the risk of serious injury to hands.
carton.
6. Place the accessories in the carton.
7. Close the carton.
ATTENTION: When transporting the appliance on vehicles,
secure it according to the directives in force so that it cannot
slide or tip over.
ATTENTION: Users are advised to always wear protective
gloves, to avoid the risk of serious injury to hands.
11. Exhaust filter
12. Motor round filter
13. Vacuum Cleaner Bags
14. Rubber seal
ATTENTION: Users are advised to always wear protective
gloves, to avoid the risk of serious injury to hands.
ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.