Corrective Action; Warranty Limitations - CULUS pod1 plus Mode D'emploi

Problem Solution
1) Fill the tank with water
Pressing the
2) Check if the water tank is well located.
dispenser buttons
3) Lift the lever to permit air outlet take the pod
(D-E), no drink is
off and wait for a while to let the pump be cool
delivered.
, close the lever again. and
buttons (D-E)
4) Empty the pods receptacle and reset the coffee
function: turn the machine off and on again
switching the main switch (9) off and on.
If you cannot solve the problem, you are
kindly requested to contact your service
center.
Press one dispenser button (D-E) and while water is delivered, slowly
The lever (1) will not
open the lever (1)
slide properly.
Problem
Coffee is no longer dispensed
It is not possible to dispense
coffee or boiling water
Coffee/tea is cold
The pump is too noisy
A few drops come out of the
dispenser, especially when the
machine is warming up
Coffee tastes sour

WARRANTY LIMITATIONS

Warranty does not cover repairs caused by:
- Malfunctions caused by water scale and by failure to periodically de-scale the unit
- Malfunctions caused by operating the machine at voltages other than that specified on the
nameplate
- Malfunctions caused by improper use or non-adherence to the instructions for use
- Malfunctions caused by alterations made inside the machine
press the dispenser
.
Causes
- the tank is empty
- the pump is defective
- the water tank is not fully seated
- pompa difettosa
- the heating system is defective
- the tank is empty
- the water tank is not seated
properly
- this is not a fault
-the machine was not rinsed
properly af ter descaling
15

Corrective action

- fill the tank
- contact the dealer
- seat the tank properly
- contact the dealer
- contact the dealer
- fill the tank
- seat the tank properly
- it is normal for a few drops to
come out, this is not a defect
- re-rinse the machine