Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Turning the TV On and Off
Press the POWER button on the remote control.
You can also use the POWER button on the TV.
➢
It may take a while for the picture to appear.
Viewing the Displays and Menus
Viewing the Display
Press the INFO button on the remote control.
The TV will display the channel, the type of sound,
and the status of certain picture and sound settings.
TV #1
Wed, Jan 2 12:28am
DTV Air
Dolby Digital
M. Spillane's Mike Hammer
3-
Bonocrunch
Viewing the Menus
With the power on, press the MENU button.
The main menu appears on the screen. The menu's
left side has icons: Picture, Sound, Channel,
Setup, Input, Application.
Mode
Cell Light
Contrast
Brightness
Sharpness
Color
Tint (G/R)
Detailed Settings
Press the ▲ or ▼ button to select one of the icons.
Then press the ENTER button to access the icon's
sub-menu.
➢
To move to a lower menu, turn the wheel
clockwise when the menu Display is on the
screen. To move to a higher menu, turn the
wheel counterclockwise.
Press the EXIT button to exit.
➢
It takes about one minute until the on-screen
menu disappears.
480i 4:3 English
11:36 pm - 12:42 am
: Standard
: 7
: 80
: 45
: 50
: 50
: G50/R50
English - 8
Memorizing the Channels
Your TV can memorize and store all of the available channels
for both air and cable channels. After the available channels
RETURN
are memorized, use the CH
W.LINK
through the channels. This eliminates the need to change
channels by entering the channel digits. There are three
EXIT
CH LIST
W.LINK
steps for memorizing channels: selecting a broadcast source,
CH LIST
INFO
memorizing the channels (automatic) and adding and deleting
TOOLS
channels (Channel Lists).
Storing Channels in Memory
(Automatic Method)
Before your television can begin memorizing the available
channels, you must specify the type of signal source that is
connected to the TV (i.e. an Air or a Cable system).
Press the MENU button to display the menu.
Press the ▲ or ▼ button to select Channel, then
press the ENTER button.
Antenna
Auto Program
Clear Scrambled Channel
Channel List
Fine Tune
Signal Strength
Press the ▲ or ▼ button to select Auto Program,
then press the ENTER button.
Auto Program
Select the Antenna source to memorize.
Air
Cable
Auto
Move
Press the ▲ or ▼ button to select an antenna
connection, then press the ENTER button.
➢
Air: Air antenna signal.
Cable: Cable antenna signal.
Auto: Air and Cable antenna signals.
Auto Program
Select the cable system.
Analog
STD
Digital
STD
Start
Move
RETURN
or CH
button to scan
EXIT
INFO
TOOLS
: Air
►
Start
Start
Start
Enter
Return
HRC
IRC
HRC
IRC
Enter
Return
Publicité
Table des Matières
