HH TENSOR TRE-1201 Mode D'emploi page 3

TENSOR SERIES ACTIVE LOUDSPEAKER
INTRODUCTION
The HH Tensor engineered in the UK to deliver power, performance and reliability.
The Class-D Bi-Amplifier delivers impressive output performance in an ultra-lightweight enclosure.
On-board DSP provides audio enhancements depending on audio source and includes overload protection. Four
acoustically tuned audio modes are provided for flexibility for use in a multitude of situations.
Whether that's for a DJ, live band, monitoring or announcements, the Tensor has it covered with the press of a button.
High-quality integrated two channel mixer gives multiple options for input sources. Each input has HH designed low-
noise preamps with combo XLR/TRS connectors for both Line Level and microphone gain levels.
All this contained in a multi-angle enclosure that includes three moulded carry handles, pole mount socket and four M8
suspension points.
The HH Tensor – delivering performance and reliability.
GETTING STARTED
This manual contains important information regarding correct and safe operation of your Tensor system. Please read it thoroughly in
order to get the best performance and reliability from your HH product.
Inspect the product during unpacking, If any damage is found notify the dealer you purchased it from immediately. Should you ever
need to return the unit back to the dealer or HH Electronics, ensure it is well packed and if possible use the original packaging.
POWER CYCLE
Many products have large transient surges at turn on and off which can cause damage to your speakers.
Following the sequence below for power-up and the reverse for power down will prevent this from occurring.
1
POWER
POWER SWITCH - OFF
4
INPUT 1
CONNECT INPUT SIGNAL
© 2020 HH Electronics Ltd
2
CONNECT POWER
5
POWER
POWER SWITCH - ON
Designed and Engineered in the UK by HH Electronics LTD.
3
MAIN
LIMIT
VOLUME
SET VOLUME TO MINIMUM
6
MAIN
LIMIT
VOLUME
SET VOLUME AS REQUIRED
2