Removing The Vx Driver Under Windows 2000 & Xp; Updating The Vx Driver Under Windows 2000 & Xp - Digigram VX222v2 Manuel Utilisateur

•
Read the License agreement and click on Yes to confirm.
•
Select the components to install. Select Wave if you want to install the
Wave driver in addition to the DirectSound driver. Click on Next.
•
Under XP, select Continue anyway when the following message is
displayed:
"The software has not passed Windows Logo testing".
If you have chosen to install the Wave driver, this message will appear a
second time. Select again Continue anyway.
•
Click on Finish.
The DirectSound, ASIO, (and Wave if selected) drivers are now installed.
Removing the VX driver under Windows 2000 & XP
•
Go to <Start> <Settings> <Control panel> <Add/Remove Programs>.
•
Select the 'Digigram VX Kit ...' and remove it.
•
Follow the instructions of the InstallShield wizard.
Updating the VX driver under Windows 2000 & XP
•
Remove the driver as described above.
•
Run the installation program of the new driver, as described above.
Note: If you have done an installation without selecting the Wave driver,
and you now want to install it, it is necessary to remove the
(DirectSound) driver, and then re-install it.
VX222
User's Manual
v2
11