Klarstein SHIRTBUTLER PRO Mode D'emploi page 19

4. Spread the clamps along the bottom of the garment (at the front and back in each
case on the outsides and in the middle on the button strip at the front) so that it is
weighed down and will not go out of shape when the nylon balloon is inflated.
5. Insert the mains plug into an easily accessible socket.
6. Use the Minus and Plus buttons (6/7) to set the timer to the desired duration. You
can make the following selection: 15 min, 30 min, 60 min, 90 min, 130 min and
180 min.
7. Once the nylon balloon has inflated, straighten out the garment and smooth it down
again.
8. When the set time elapses, the appliance switches off automatically.
9. Remove the garment from the nylon balloon and hanger (1).
10. Pull the mains plug out of the plug socket and allow the appliance to cool down
completely.
3. Pull the garment which is to be
pressed over the nylon balloon
and the hanger (1) and do up the
buttons if necessary. Make sure that
• the collar is fitted over the
collar section (9) on the
hanger (1),
• any button strip is over the hole
line on the nylon balloon,
• the arms of the nylon balloon
fit properly in the sleeves of the
garment and are not twisted or
scrunched up,
• all buttons on the garment
(including on the sleeves) are
done up.
EN
19