Assembly And Preparation; Special Safety Instructions - In Shape 17065 Manuel D'instructions

When the equipment is in use, it should
be monitored continuously. When the
equipment is in use, any children near it must
not be left unattended. The equipment is not
a toy.
Remember to check the equipment
regularly. Tighten all screws, bolts and nuts
on the equipment as required. Inspect the
equipment and replace any worn parts. Do
not use the equipment if it is defective.
When moving the equipment, employ the
correct lifting technique.
The equipment is only intended for indoor
use in private households.

Special safety instructions

WARNING! The pulse monitor may be
inaccurate. Training too hard may involve a
risk of personal injury or death. If you feel
unwell, stop exercising immediately.
Check before each use that the spinner bike
is stable and cannot tilt over during use.
If you adjust the handlebar or saddle, you
must not exceed the STOP or MAX marks, as
this may involve a risk of injury!
The pedals can rotate at high speed and
with great force. If they get out of control,
increase the load by turning the knob
marked TENSION. If you need to stop the
pedal rotation immediately, press the red
emergency stop button.
Preparations for assembly
Two people are required to assemble the
spinner bicycle.
Lay all the pieces out on the � oor and check
that all the parts are there.
Please refer to the illustration and parts list at
the back of the manual.
Use the tools provided for assembly.

Assembly and preparation

Step 1
Screw the front stabiliser (04) and the rear
stabiliser (07) securely to the frame (01) using
bolts (05), washers (03) and nuts (02).
GB
21