Camera Installation
Before you install the camera, carefully plan where and how it will be
positioned, and where you will route the cable that connects the camera to
the power adaptor.
Before starting permanent installation, verify its performance by observing
the image on the receiver when camera is positioned in the same location/
position where it will be permanently installed and the receiver is placed in
the location where it will be used most of the time
Installation Warnings
Aim the Camera(s) to best optimize the viewing area: Select a location for the
camera that provides a clear view of the area you want to monitor, which is free
from dust, and is not in line-of-sight to a strong light source or direct sunlight.
Avoid installing the cameras where there are thick walls, or obstructions
between the Cameras and the Receiver.
Night Vision
This camera has built-in IR LEDs, which provides the camera with the ability
to view images in no/low light conditions. It is important to use the provided
power adaptor( and not the Batteries) when using the camera for prolonged
periods in low light conditions, as the built-in IR LEDs will drain the battery
more quickly than regular daytime use.
Installing the Camera
•
Carefully unpack the Camera
NOTE: If you are installing Cameras that did not come
with the System, please see the Pairing Camera sec-
tion of this manual for details on installation.
•
Mount the camera to the wall
Mark the position of the screw holes on the wall.
Drill holes and insert 2 screws. Firmly attach the
camera to the wall by placing the stand over the
installed screws and pushing the base downwards
to secure.
8
I
WMV850 USER MANUAL
All manuals and user guides at all-guides.com