Before Use - FITFIU Flying Manuel D'instructions

BEFORE USE

Button
Power/Light Button
Function button
Adjustment button
ADJUSTMENTS
•
Press the function button and the settings button (
• Press the Settings button (
• Press the power button (
• Briefly press the power/headlight button to exit the setting mode
• Press the function button and the settings button (
Code
P01
P03
P04
P06
P07
Speed limit adjustment (10-40Km/h). After the speed limit has been reached, slow down before
P08
P09
P16 Total mileage traveled, access the parameter, press adjustment button 5 seconds to clear
NOTE: The display contains program codes up to P17, because it is a generic display, but only the
previous described programs are usable.
Short press
Turns the headlight on and off
(with the scooter on). Accept
parameters.
Select the type of speed:
• slow (EC0:15km/h)
• average (MID:22km/h)
• fast (HIGH: 28km/h)
Sample: ODO, TRIP, battery
status, engine speed
) to select the parameters.
) to make the changes.
Adjust the backlight brightness (1-3)
Set voltage mode (24/36V), default is 36V
Standby time (O- 60Min), 0 is deactivated
Wheel diameter in inches
Pole Ratio Adjustment
Non-zero start setting, 0 is zero start, 1 is non-zero start
ELECTRIC SCOOTER FLYING
Operation
Long pulse
Turns the scooter on and off.
While driving - conventional cruise.
In stop - low speed cruise (6Km/h).
+ ) for a long time to enter settings.
+ ) for a long time to exit the settings.
Function
starting.
35
EN