CHESTER GT67006 Mode D'emploi page 11

Pumping very dirty water or muddy water may shorten the life of the pump.
The pump must not run empty. The pump must not be exposed to frost.
To guarantee that the pump works properly, the bottom of the shaft must be kept free of
sludge and dirt of all kinds.
Never insert your hand into the pump's suction inlet when it is in use or is connected to the
mains.
Always check the cord and plug before using the pump, as defective cords may cause electrical
leakage on contact with water, producing an electric shock.
In addition, the following safety instruction must be observed :
• Unauthorized conversion and/or modification of the device are inadmissible because of
safety and approval reasons (CE). Such acts invalidate the warranty.
• The use of the pump is authorized only with residual current – protect switch (max.
residual current 30mA according to the relevant VDE 702 regulations).
• The voltage indicated on the type label must correspond to the used power supply voltage!
• Keep electrical devices out of reach of children. Be especially careful if children are around.
(Children could try to introduce objects into the device), this represents a life-threatening
electric shock. This product is not a toy and should be kept out of reach of children.
• Persons must not stand in the delivery medium of the pump during operation!
• Make sure that all electrical connectors are located in areas protected floods and weather
influences!
• The installation location of the pump must not be changed as long as the pump is in
operation!
• Make sure that all electrical connections, connecting cables between the pump and
possible extension cables are in accordance with the instructions of use!
• Make sure that the ground wire (yellow/green) is not interrupted neither in the power
line, in an eventually connected extension line, not in/at the device, since an interrupted
ground wire represents a danger to life! Operating the device without a ground wire
connection is not permitted!
• Never disconnect security devices!
• Never use the line cord to transport the pump!
• Disconnect the pump from the mains before cleaning it if you do not use a longer period
of time.
• If there is any reason to believe that safe operation has become impossible put the pump
out of operation and secure it against any unintended operation. Pull the power plug out
of the wall outlet! Safe operation must be presumed to be no longer possible, if :
o The pump and the connecting lines show visible damages
o The pump does not operate any longer
o The pump was transported or stored under unfavorable conditions
• Consequential damages to the pump caused by a flood must be ruled out by the user by
way of taking appropriate measures (for example through the installation of an alarm
device, a spare pump, etc.)!
www.chestergarden.be
GB
11