Velleman PIR105 Mode D'emploi page 5

4. Installation and Connection
V. 01 – 11/12/2017
Installation Guidelines
Avoid pointing the detector towards objects
with highly reflective surfaces such as
mirrors.
Avoid pointing the detector near heat
sources such as heating vents, air
conditioning units, etc.
Avoid pointing the detector towards objects
that may move in the wind such as
curtains, plants, etc.
Install the detector at a distance of
minimum 60 cm when using a lamp of 60 W
or more.
Installation
Install this detector flat on a wall or in a
corner. Use an appropriate screwdriver and
the included screws and nylon plugs.
1. Open the device by turning the upper
cover.
2. Connect the detector (see below) and
fix the bottom.
3. Re-install the upper cover to close the
detector.
Connection Guidelines
Risk of electroshock! Touching live wires
 Have the device installed by qualified
can cause life-threatening electroshocks.
 Disconnect the power source.
personnel.
 Cover and shield any adjacent live
 Ensure the device cannot be switched on. components.
PIR105
5 ©Velleman nv