Firstech DroneMobile DR-2000 Guide D'installation page 21

Option Programming Using a Remote
Using a remote is a timed process so read this section in its entirety before beginning. IMPORTANT:
Special Option Groups cannot be programmed with a remote – the OP500 must be used.
Select the option menu that contains the desired programming option.
STEP 1:
Scroll through menu allowing for 1 parking light flash.
STEP 2:
Once finished scrolling through the menu wait for the parking lights flash confirming the
STEP 3:
option number. i.e. option 2-04 will flash 4 times. Then use 1 or 2 Way table below to select the
option corresponding to your desired setting.
Resetting to Factory Defaults: To reset the options in a particular menu group, enter the menu shown
in the above tables. To reset options with a 2 Way remote tap button 3 three times. To reset options
with a 1 Way remote tap the Key/Start button 3 times. Wait for the parking lights to flash between each
tap. After the third tap, the option menu will reset and the parking lights flash three times. This must be
done for each option group that needs to be reset.
To program options use the following button combinations:
All manuals and user guides at all-guides.com
TM
DR-2000 Install Guide
Programming
Copyright 2011 Firstech, LLC. | 20