Firstech DroneMobile DR-2000 Guide D'installation page 19

2-07 Low Battery Warning - This option is off. When the system is
armed and this feature is programmed, Drone will monitor the voltage of the vehicle's
battery at its connection point. When the battery voltage drops to or below 11 volts the
Drone will send a Low Battery Notification and page to the 2 way. The remote will beep
several times for 5 seconds, every 50 seconds, 3 times and flash the battery indicator on the
remote. When you query the remote or unlock/disarm the system the remote will display the
voltage of the vehicle's battery. In Type 2 installations, this option must also be turned on
the remote start control module.
2-08 Triple Pulse Trigger for Remote Start - This option will change the behavior of the
Programmable Output 3. It will provide a triple pulse output for triggering the remote
starter.
IMPORTANT: The OP500 is required to change settings in Special Option Groups 1 and 2.
Special Option Group 1
1 Diesel Timer – Option 1-03 must first be set to setting 2. This special option allows a
specific wait to start time (in seconds) to be programmed. This prevents the need for a timer relay and
eliminates a connection to the "wait to start" wire.
2 Aux 1 Output Timing – Option 2-03 must first be set to setting 4. This special option allows
a specific output duration for Aux 1 to be programmed.
3 Aux 2 Output Timing – Option 2-04 must first be set to setting 4. This special option allows
a specific output duration for Aux 2 to be programmed.
Special Option Group 2
This special option group allows you to determine the output type of the POC wires. For example, if
you want to set POC #1 (default setting lock output) to Auxiliary 1, you will need to change from 0 to
number 6. This must be done using the OP500.
All manuals and user guides at all-guides.com
TM
DR-2000 Install Guide
Programming
Copyright 2011 Firstech, LLC. | 18