Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
• Fixture must be connected to a 120 Volt, 60 Hz power source. Any other connection
voids warranty.
• This motion activated twin floodlight should be installed by persons with experience in
household wiring or by a qualified electrician. The electrical system, and the method of
electrically connecting the fixture to it, must be in accordance with the National Electrical
Code and local building codes.
• For proper operation and protection against damage, the motion sensor head adjustment
knobs must be facing the ground.
• Disassembly of your fixture will void the warranty.
SAVE THESE INSTRUCTIONS.
For best results
• Install your fixture 8-12 feet above ground (motion detector is less
sensitive above 12 feet).
• Locate fixture so motion moves across detection zone (M).
• Locate fixture away from heat producing sources to prevent false
triggering. Also be very careful not to include objects such as
windows, white walls and water in the detection zone whenever
possible.
• Locate fixture away from moving objects such as trees and street traffic.
• Do not install more than one motion detector on one wall switch.
Mounting your fixture
Step 1:
Turn off the power at the main fuse/breaker
b ox.
Step 2:
Line up the holes on the mounting bracket with
the holes on your junction box. Using either (2)
#6 screws or (2) #8 screws (depending on size
of the holes in your junction box), attach the
mounting bracket to your junction box (N).
Step 3:
Hang one end of the mounting hook onto the mounting bracket
(using the hole in the bracket, see drawing), and hang the
light fixture on the other end of the mounting hook. NOTE:
Carefully hang the fixture at the base of the lampholder
assembly as shown. This will free-up your hands for
wiring.
Step 4:
Thread fixture wires through coverplate gasket.
Step 5:
If the supply wires coming from your house are
solid, you can use the Quick-connect™ wire system to attach
your light fixture. NOTE: Quick connectors can only be used with
solid wire supply leads. Simply insert the black supply wire
from your house into the quick connector with black wire
coming from the fixture. Repeat for house white wire,
matching to the connector with the white wire. Push
both wires firmly into holes to insure that they are seat-
ed properly and securely (O). It's that easy! Proceed to
Step 7.
Step 6:
If the supply wires coming from your house are strand-
ed, remove the quick connectors from the end of the light
fixture wires by turning them repeatedly from left to right
while pulling. Repeat until they are both removed.
Remember: Quick connectors can only be used with
solid wire supply leads. Do not attempt to use with
other electrical fixtures! These connectors are
designed to withstand the temperature and Voltage requirements of this
Regent product only. Once the connectors have been removed,
connect black wire to house black wire and connect white wire to house white
wire using the wire nuts provided.
Step 7:
Attach copper (or green) colored ground wire (coming from the fixture coverplate)
to house ground wire using wire nuts provided.
Step 8:
Remove fixture from hook and discard hook. Attach fixture to the mounting
bracket using the center bolt provided. Insert plastic color matched plug in
center bolt hole for finished appearance.
Your fixture mounts to the
following standard junction boxes:
Round
3
M
Rectangular (horizontal)
Octagonal
N
(wall mount)
(eave mount)
Solid
Prewired
fixture
quick
wire
connector
Solid house
O
supply wire
Publicité
