Installation - Klarstein FROSTICA Mode D'emploi

INSTALLATION

Install the filter
1 Water outlet tube of the filter hull
2 Fixed board of the filter hull
3 Cover of filter hull
4 Washer of Connector
5 Connector of the filter hull
Insert filter
1 Set the washer into the groove of the upper filter hull.
2 Put the filter core into the filter hull, then cover both with the cover of the filter hull.
3 Fasten the fixed board of the filter hull on the filter cover with screws.
4 Connect the filter hull connector with the water inlet tube of the filter hull, install the
washer, then connect it to the end of the filter cover with the inscription "in" on it.
5 Connect the filter hull connector with the water outlet tube of the filter hull, install the
washer, then connect it to the end of the filter cover with the inscription "out" on it.
6 After completing the installation, fix the filter to the back of the ice maker with
screws.
7 Connect the water inlet tube of the filter hull to the water supply.
8 Connect the water outlet tube of the filter hull to the water inlet valve of the ice
maker.
6 Water inlet tube of the filter hull
7 Filter core
8 Washer
9 Filter hull
EN
17