Installing Windows - ASROCK B75M-ITX Mode D'emploi

2.11 Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical
drive first. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from up to bottom side
to install those required drivers. Therefore, the drivers you install can work properly.

2.12 Installing Windows

XP 64-bit Without RAID Functions
If you want to install Windows
bit OS on your SATA / SATA2 / SATA3 HDDs without RAID functions, please follow
below procedures according to the OS you install.
2.12.1 Installing Windows
If you want to install Windows
HDDs without RAID functions, please follow below steps.
AHCI mode is not supported under Windows
Using SATA / SATA2 / SATA3 HDDs without NCQ function
STEP 1: Set Up UEFI.
A. Enter UEFI SETUP UTILITY
B. Set the option "SATA Mode Selection" to [IDE].
STEP 2: Install Windows
28
®
7 / 7 64-bit / Vista
®
7 / 7 64-bit / Vista
®
XP / XP 64-bit Without RAID Functions
®
XP / XP 64-bit OS on your SATA / SATA2 / SATA3
Advanced screen
®
XP / XP 64-bit OS on your system.
ASRock B75M-ITX Motherboard
TM TM
/ Vista 64-bit / XP /
TM TM
/ Vista 64-bit / XP / XP 64-
®
XP / XP 64-bit.
Storage Configuration.