Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3 For the installer
General
RSV/RSH is a series water heater, that is suitable for connection to an exter-
nal heat source.
The inner cylinder of the water tank is produced from pickled stainless steel
for increased corrosion resistance. The water heater is equipped with a
charge coil that heats the domestic water, resulting in excellent properties
for hot water charging.
The water heater is designed and manufactured for a maximum cut-off pres-
sure of 10 bar in the water heater and 10 bar on the primary side. Maximum
permitted temperature is 85 °C.
The insulation is polyurethane, which provides excellent heat
insulation. The outer shell of RSV/RSH has a stainless steel look. The insulati-
on and jacket can not be removed from the tank (e.g. foor transport purpo-
ses).
2 Delivery and handling
RSV is equipped with a submerged tube for the sensors for external control
and display of hot water heating.
RSH is equipped with a submerged tube for the sensor for
external control of hot water heating.
Transport
Transport
The Titanium HA - WH5 F / FS should be
transported and stored vertically in a dry place.
The RSV/RSH should be transported and stored vertically in a
dry place.
Assembly
The RSV models are designed for upright installation.
The RSH model is designed for horizontal installation.
The water heater's installation area should always have a
temperature of at least 10 °C (frost-free).
Position the boiler on a firm base that can take the weight,
preferably on a concrete floor or foundation. Use the product's
adjustable feet to obtain a horizontal and stable set-up.
Assembly
The water heater is only designed for upright installa-
tion.
Position the water heater on a m base that can bear
its weight, preferably on a concrete
tion. Use the water heater' s adjustable feet to obtain
a horizontal and stable set-up.
Pipes must be routed from the safety valve to a suit-
able drain.
The water heater' s installation area should always
have a temperature of at least 10 °C and max 30 °C.
Remember to rotate the cylinder in a direction that
allows easy access to the immersion heater and the
2 Delivery and handling
Transport
The Titanium HA - WH5 F / FS should be
transported and stored vertically in a dry place.
0
R
Assembly
The water heater is only designed for upright installa-
tion.
Position the water heater on a m base that can bear
its weight, preferably on a concrete
tion. Use the water heater' s adjustable feet to obtain
a horizontal and stable set-up.
Pipes must be routed from the safety valve to a suit-
able drain.
The water heater' s installation area should always
have a temperature of at least 10 °C and max 30 °C.
Remember to rotate the cylinder in a direction that
allows easy access to the immersion heater and the
r or founda-
electrical box.
R
0
r or founda-
21
Publicité
Table des Matières
