Yamaha AVENTAGE RX-A1080 Guide De Démarrage Rapide page 16

1
Turn on the subwoofer and set the volume to half.
If the crossover frequency is adjustable, set it to maximum.
VOLUME
MIN
2
Place the YPAO microphone at your listening
position and connect it to the YPAO MIC jack on
the front panel.
The screen below appears on the TV.
Note
Place the YPAO microphone at your listening position (same height as your ears).
We recommend the use of a tripod as a microphone stand. You can use the tripod
screws to stabilize the microphone.
16
En
CROSSOVER/
HIGH CUT
MAX MIN MAX
3
Use the cursor keys to select "Start" and press
ENTER.
The measurement will start in 10 seconds.
It takes about 3 minutes to measure.
The screen below appears on the TV when the measurement finishes.
Note
If an error message (such as ERROR 1) or warning message (such as
WARNING 2) appears, see "Optimizing the speaker settings automatically
(YPAO)" in the Owner's Manual.
4
Select "Measurement result" and press ENTER to
display the result, if necessary.
After confirming the result, press RETURN to return to the "Measurement
Finished" screen.
5
Use the cursor keys to select "Save" and press
ENTER.
6
Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.