Jump Starter; Warnings; Procedure - Wagan Tech 300 Amp Battery Jumper 2467 Guide D'utilisation

2. Open the dust cover on the charging jack.
3. Plug the small end of the DC power cord into the Battery Jumper 's charging jack.
4. Plug the large end of the DC power cord into an accessory (cigarette lighter) socket.
5. The Battery/Charging Indicator will light up red during the charging process. Do NOT
charge for more than 12 hours at one time�
6. When charging is complete, the indicator will turn green. Disconnect the power cord from
the accessory socket first, then from the unit's charging jack.
7. Replace the dust cover on the charging jack.
8. Press the Battery Status Button and observe the Battery Status/Charging Indicator for the
state of charge on the unit's internal battery. The Battery Status/Charging Indicator should
be lit green if charge is complete.

JUMP STARTER

Warnings

• Lead-acid batteries can release explosive gasses. Failure to follow instructions
may cause property damage, explosion hazard, and/or personal injury.
• Do not smoke while jump starting.
• Jump start a vehicle or boat in a well ventilated area.
• Do not attempt to jump start a frozen battery.
• This product is not intended for use in the rain or temperatures above 130°F.
• Do not let the jumper cables or other attached appliances get wet.
• Do not wear vinyl clothing when jump starting—friction can cause static
electricity sparks.
• Remove all metal jewelry to avoid short circuits.
• Always use safety glasses when jump starting battery. Keep battery terminals clean and be
careful to keep corrosion from coming in contact with eyes—acid can cause blindness and/
or severe burns.
• Never allow red and black clamps to touch or connect to the same piece of metal—this can
cause short-circuits, power arcing, and/or explosion.
• Make sure someone is available to give assistance if needed.
• Keep out of reach of children.

Procedure

CAUTION: If the engine fails to start after three attempts, discontinue jump start procedure.
Excessive engine cranking can damage the vehicle's starter motor. Look for other problems that
may need to be corrected or call for professional service.
1. Review the jump starter warnings.
2. Put the vehicle's gear is in "park" position and make sure the brake is set.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2017 Wagan Corporation. All Rights Reserved.
11