Accessories - Lionelo Margareet Serie Manuel De L'utilisateur

Porte-bébé ergonomique
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
In this position the front panel should be wide - the front panel width adjustment
button (7) fastened on the hip belt.
Note! For the sake of safety, if you wish to place your child in this position,
ask another person for help!
1.
Fasten the hip belt (6). Lock the hip belt buckle with the use of the double
protection button (10). Adjust the hip belt to your waist (fig. 4a). The carrier's
front panel should be centered behind you.
Important: before you take another step, make sure the hip belt has been
fixed properly!
2.
Bend forward, ask your partner to put the child on your back gently.
NOTE! The child must be held until the carrier has been secured fully.
3.
Child's legs must wrap around the parent's waist (fig. 4b).
4.
Ask your partner to lift the carrier's panel and wrap the child's back with it
(holding it all the time and securing against falling with another hand (fig. 4c).
5.
Use your partner to pull the left and right hand through shoulder belts (fig. 4d).
6.
Link the shoulder belts (fig. 4e) and adjust them (4).
7.
Adjust the shoulder belts with the use of the shoulder belts adjustment
buckle (2). The child must be wrapped properly and belts tightened up so
that they do not squeeze the child's body too much.
Monitor your child permanently to make sure its position is comfortable and its
breath is not hindered.

4. Accessories

A.
Hood
NOTE! If you use the hood, make sure it DOES NOT cover child's entire face.
Check the child regularly. Make sure the hole allows a sufficient flow of air.
The product is equipped with a hood which secures the child's head (e.g. when it
sleeps, against wind and sunlight). To use it, take the hood out through the hole (4)
and put both fasteners in the designated spot on the shoulder belt (marked as 3 in the
fig. 1). The hood must not cover the child's face; it must protect the back of the head.
B.
Belt guards (pads)
The product is equipped with cotton belt guards with snap fasteners. They protect
the shoulder belts against dirt and child's saliva. The cotton guards can be easily
removed and washed.
EN
‑ 8 ‑

Publicité

Table des Matières
loading

Table des Matières