Continuous Drainage; Cleaning And Storage; Filter Cleaning - Keystone DD7L Junior Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Continuous Drainage

It is possible to connect the drainage hose to the dehumidifier for permanent water drainage. Simply connect the hose to
the drain spout and ensure that the end of the hose is lower than the drain opening, otherwise the water will not drain and
flooding may occur.
If you find that the water does not flow down the hose then check that it is running downhill, is not kinked, all excess tube
has been cut off and is not blocked. If the water still does not flow then make a 4mm hole, 30mm from the spout in the top
of the hose. This will balance out the air pressure and allow the water to flow.
When you no longer wish to use the permanent water drainage, disconnect the drainage tube from the device. Ensure that
the water container is positioned correctly.
This dehumidifier does not come with a hose to reduce the amount of plastic in landfill. Hoses can be purchased

7. CLEANING AND STORAGE

Always turn the dehumidifier off and unplug it from the socket before cleaning. Clean the dehumidifier with a soft, dry cloth,
do not allow the dehumidifier to get wet.

Filter Cleaning

Water spigot
locally or direct from Keystone.
8 [EN]

Publicité

Table des Matières
loading

Table des Matières