NEXPEAK K1 Guide De L'utilisateur page 3

NEXPEAK K1 Smart Diagnostic Tablet--User Guide
NEXPEAK K1 VCI (Vehicle Communication Interface ) Configuration
The NEXPEAK K1 VCI is used to access the vehicle data and send back
data to K1 Tablet, it works only under 12V battery voltage supply.
Vehicle's DLC (Data Link Connector) location
* Remember to remove the VCI connector from DLC
If it keeps unused.
* Check and clean the car's OBD II socket and make
sure it's not aging before the connection.
Install the VCI Connector
1. Locate vehicle's DLC socket: The DLC(Data Link Connector) is typically a 16-pin connector where diagnostic code readers interface with the
vehicle's on-board computer. It is usually located on the driver's side, about 12 inches away from the center of the dashboard. See Figure
DLC Location. In case no DLC is found, please refer to Automobile Repair Manual.
2. Plug the VCI connector into the vehicle's DLC(It is suggested to use the OBDII extension cable to connect the DLC and the VCI). Normally
the power indicator of the VCI will light up.
Bluetooth communication indicator(Blue)
(By default, it is in Bluetooth mode when the
connector is powered up and illuminates blue.)
(Reserved for subsequent function extension.)
1
OBD-16 Pin Connector
(To connect on vehicle's OBD II DLC.)
The VCI connector is used to
access the vehicle data and
then send it to the handset via
Bluetooth, which only works
with the vehicle with 12V
battery voltage
Power indicator(Red)
(It lights up while the VCI connector
is plugged into the vehicle's DLC.)
Mini USB port
EN