Flap Replacement; Maintenance & Storage - Bestway AQUAROVER FLOWCLEAR 58622 Manuel D'utilisation

- Replace a damaged flap immediately with a new one before the next operation.

Flap replacement

MAINTENANCE & STORAGE
NOTE:
1. Battery discharges on its own during storage. Make sure to fully charge the robot
before storage.
2. You must recharge the battery at least once every three months when it is not in use.
 Unplug the external adaptor from the socket and the charging cable from the external
adaptor and robot..
 Detach accessories from the robot. If necessary, rinse the robot and accessories with
fresh water. DO NOT use detergent.
 Be sure to drain the water from the robot before storage.
 Use a damp cloth to clean and dry the robot and its accessories.
 Store them in a well-ventilated area away from sunlight, heat, ignition sources, pool
chemicals and from children. Ambient temperature for storage should be 10˚C – 25˚C
(50˚F – 77˚F). NOTE: A higher storage temperature may reduce the battery life.
WARNING!
Under no circumstances should you attempt to disassemble the swivel head and
-
replace the impeller, motor and battery by yourself.
CAUTION!
 Excessive heat can damage the battery and reduce the lifespan of your robot as a
result.
 Consult your dealer regarding battery replacement if the following happens:
Battery does not charge fully.
-
Battery operation time is noticeably reduced. Observe and record the run times of
-
the first few operations (on a full charge). Use these run times as a reference point
for comparison with run times in the future.
 The battery must be removed from the robot before it is scrapped.
 The robot must be disconnected from the supply mains when the battery is being
removed.
 The battery is to be disposed safely in accordance with local ordinances or
regulations.
NOTE: Incorrect maintenance may reduce the battery life and affect its capacity as a result.
13