Replacing Halogen Light Bulbs - SCHOLTES HSB 308 IX NA Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• By pressing key F for two seconds (with the hood
switched off) the "clean air" function is activated. This
function switches the appliance on for ten minutes
every hour at the first speed. As soon as this function
is activated the motor starts up at the first speed for ten
minutes, During this time key F and key C must flash
at the same time.
After ten minutes the motor switches off and the LED
of key F remains switched on with a fixed light until
the motor starts up again at the first speed after fifty
minutes and keys F and C start to flash again for ten
minutes and so on.
By pressing any key for the exclusion of the hood light
the hood will return immediately to its normal function-
ing (e.g. if key D is pressed the "clean air" function is
deactivated and the motor moves to the 2nd speed
straight away. By pressing key B the function is de-
activated).
• The "automatic stop timer" delays stopping of the hood,
which will continue functioning for 15 minutes at the operat-
ing speed set at the time this function is activated.
• Active carbon/grease filter saturation:
- When button A flashes at a frequency of 2 seconds,
the grease filters must be cleaned.
- When button A flashes at a frequency of 0.5 seconds,
the carbon filters must be replaced.
After the clean filter has been replaced, the electronic
memory must be reset by pressing button A for
approximately 5 seconds, until the light on the button
stops flashing.
MAINTENANCE
• It is recommended to operate the appliance prior to
cooking. It is recommended to leave the appliance in
operation for 15 minutes after cooking is terminated
in order to completely eliminate cooking vapours
and odours. The proper function of the cooker hood
is conditioned by the regularity of the maintenance
operations.
• The anti-grease filters capture the grease particles
suspended in the air, and are therefore subject to
clogging according to the frequency of the use of the
appliance. In order to prevent fire hazard, it is recom-
mendable to clean the filter at a maximum of 2 months
by carrying out the following instructions:
- Remove the filters from the cooker hood and wash
them in a solution of water and neutral liquid detergent,
leaving to soak.
- Rinse thoroughly with warm water and leave to dry.
- The filters may also be washed in the dishwasher.
The aluminium panels may alter in colour after several
washes. This is not cause for customer complaint nor
replacement of panels.
• Clean the fan and other surfaces of the cooker hood
regularly using a cloth moistened with denatured alco-
hol or non abrasive liquid detergent.
FUSE
• The halogen lamps circuit is controlled by a fuse 5x20
mm, 125V 5A. In case of necessity it can be replaced
only by specialized personnel.
• Replacing halogen light bulbs (Fig.8).
To replace the halogen light bulbs B, remove the glass
pane C using a lever action on the relevant cracks.
Replace the bulbs with new ones of the same type.
Caution: do not touch the light bulb with bare hands.
GB
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hsb 368 ix na

Table des Matières