Radio Compliance Statements - TEKTELIC COMMUNICATIONS T0004855 Mode D'emploi

3. Radio Compliance Statements

Federal Communications Commission
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antennas used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
Industry Canada
This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two
conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.
This radio transmitter 22504-T0007871 has been approved by Industry Canada to operate with the antenna listed below with
the maximum permissible gain or lesser and required antenna impedance for the antenna indicated. Antenna types not
included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this
device.
This device complies with IC radiation exposure limits set forth for an uncontrolled environment. This device should be installed
and operated with minimum distance 0.2 m between the radiator and your body.
This device has been designed to operate with an omni-directional antenna having a maximum gain of 0.4 dBi in the 902-
928MHz transmit band. Antennas having a gain greater than 0.4 dBi are strictly prohibited for use with this device. The
required antenna impedance is 50 ohms.
During product operation, always keep a separation distance of at least 0.2m from any connected antenna(s). Before servicing
the product, the antenna(s) or cables, turn off the transmission function or the unit power if you have to get closer than the
minimum separation distance.
Kona Micro User Guide
TEKTELIC Communications Inc.
T0005281_UG Version 1.3
Page 14 of 25