Functional Description - ITC STS10 Guide D'utilisation

FUNCTIONAL DESCRIPTION

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
ASSEMBLY
n
n
STAND
1. Loosen the Folded-position lock knobs (T in Functional Description,
2. Swing the Folded-position lock plate up into its horizontal storage position,
3. Tighten the Folded-position lock knobs to hold the plate in it horizontal
4. Unfold the legs.
5. Tighten the Leg brace lock knobs (X in Functional Description, above) to
WARNING: Stand maximum weight: 68 kg (150 lb.) Be sure stand is tight,
!
Stand up wheels
Transport handle
Drain plug
Water tank
Parallel guide
45 degree angle guide
45 degree bevel guide
Belt cover
Shaft lock button
Circuit breaker
On/Off switch
Switch box
2.5 HP motor
Blade irrigation nozzle
Blade guard lock knob
Blade guard
10" continuous rim diamond saw blade
Water pump
Rubber-padded sliding table
Folded-position lock knob
Folded-position lock plate
Rear folding leg
Front folding leg
Leg brace lock knob
Folded transport wheels
Cut depth lock knob
Some parts of the 10" Sliding Tile Saw may already be assembled in the
carton, rendering some of the assembly instructions below redundant.
For shipping, the legs are locked in the folded position with slots in the
Folded-position lock plate (U in Functional Description, above) engaging a
pin on each leg.
above).
releasing the leg pins.
position.
hold the legs erect.
secure and on a level surface before using.

v.081126