AL-KO AMS2 Mammut Einachs Instructions De Montage page 10

en
Example 1
Example 2
4. Put together the spaces for the vehicle. For this purpose, use the included plastic threaded pins (2).
The combination of spaces must be the same on both sides! Min. spacer: 10 mm.
5. Insert the right carriage bolts (3 -a) into the guide profile.
Up to 25 mm distance: 12x55
6. Place the required spacers (3 -b) onto the carriage bolts.
7. Hold the exterior attachments (4 -a) onto the outside of the frame and thread the cross beam connec-
tion (4 -b) into the lug.
We recommend performing work step 8 with two persons!
8. Insert the Mammut drive with the bolts into the available attachment holes of the frame (5).
9. Install the washers and nuts. Tighten the nuts by hand.
The cross beam connection is secured.
10.Only perform this step for the tandem installation.
Mark the white cable plug from the Mammut drive with a water-proof pen.
1 = Drive front left
2 = Drive front right
1
3
11. Lay the cable of the Mammut drive to the suitable location through the frame part and/or under the
frame part.
12.Insert the centre cross beam into the connectors.
13.Insert the M12x30 bolts with the washers and nuts in the elongated holes and take the mean of the
cross beam piece (7).
The overlap with the cross beam connection should be the same on both sides!
14.Set the Mammut drive to the right distance from the wheel and tighten the nuts by hand (8).
Use the included distance block to check your work: 20x20x35 mm (8-a). Distance of wheel to Mam-
mut roller: 20 mm.
15.Tighten the bolts on the cross beam centre piece by hand.
16.Lower the vehicle and check the distance when the wheel is compressed and adjust if necessary
according to (1 / 8).
17.Move your caravan again to a comfortable work height and secure it.
18.Level the Mammut drive.
19.Then tighten all bolts to a torque of 75 Nm.
10
measured: 129 mm
measured: 140 mm
2
4
(129 -115 = 14) Use spacer 10 mm
(140 -115 = 25) User spacer 10 and 15 mm
3 = Drive rear left
4 = Drive rear right
1653922_b