Names Of The Parts - Seiko GPS Solar Manuel D'instructions

Standard Charging Time
GPS signal reception consumes a lot of energy. It is necessary to charge the watch by exposing
it to light so that the indicator hand points to the "middle" or "full" position. (If the charging
status is displayed as "low, " the reception will not start even with manual GPS signal reception.)
Illumination Light Condition
lx (LUX) source (Example)
700 Fluorescent light General offices
3,000 Fluorescent light 30W 20cm
Fluorescent light Cloudy day
10,000
Sunlight 30W 5cm
Sunny day (Under
100,000 Sunlight the direct sunlight
on a summer day)
The figures of "Time required for charging the watch to start moving at one- second intervals"
are estimations of time required to charge the stopped watch by exposing it to light until it
moves at steady one-second intervals. Even if the watch is partially charged for a shorter period,
the watch will resume one-second- interval movement. However, it may shortly return to two-
second-interval movement. Use the charging time in this column as a rough guide for sufficient
charging time.
 The required charging time slightly varies depending on the design and the dial color of the watch.
6
In the state where
From the state where the watch
the hand moves (the
is stopped (not charged)
watch is charged)
To one-second
To fully
interval movement To move for one day
charged
is secured
－ －
3.5 hours
420 hours 12 hours 1 hours
115 hours 4 hours 15 minutes
50 hours 1.5 hours 10 minutes
2

Names of the parts

Hour hand
Second hand
Indicator hand
 Position of each display may differ depending on the model (design).
Minute hand
Button A
Crown
Date
Button B
7