Invicta IWAKI Notice Particulière D'utilisation Et D'installation page 18

Whatever the operating mode used (Rated power or Slow combustion), make sure each load of wood lights as soon as it is placed in
the appliance and that it continues to burn. If this does not happen, open the "firing rate" control to the "lighting" position for a few
moments until the wood lights properly:
During the combustion phase of the volatile part of the wood, it is essential to avoid operation without full fire, failing which the
appliance and the chimney flue will be soiled and effluents harmful to the environment and health will be released into the
atmosphere.
Post combustion activated =
"Hot and clean"
Clean
window
Primary
air
Regulation controls:
Systematically use the heat resistant glove supplied with the appliance to operate the controls which can be very hot.

Firing rate control: Located on the facade, this control is used to modulate the appliance firing rate between "Rated power" and "Extended
combustion (see diagrams on page 7)

Lighting control: Using the firing rate control beyond the "rated firing rate" position provides additional air for lighting. This position is
reserved for lighting and re-starting operations and must not be used for more than 30 minutes as this may cause damage to the appliance
and its surroundings. The appliance must be kept under surveillance the entire time this position is used.

Secondary air control: This control should remain open for effective performance and clean combustion. Closing this control is only
justified if the draught is higher than recommended (see above). It should never be completely shut. Once this adaptation has been made,
do not use the secondary air control. Only use the firing rate control to vary the appliance power.
XD, le 06/12/2021
IWAKI wood stove
GOOD
appliance
Post
combustion
air
Bed of
embers
Principle diagram
reference P610644
Flameless combustion =
BAD
"Cold and dirty"
appliance
Dirty
window
Page 18 / 21