Removal Of The Bottom Housing Cover - Oki LD610 Guide D'installation

Removal of The BoTTom housing CoveR

1. Make sure the printer is powered off and disconnect the
power cable and interface cable.
2. From the base of the printer, remove three screws (circled)
as shown.
CAUTION:
Ensure not to scrape the window portion when the
printer is turned over.
3. Remove the Bottom housing cover.
Proceed to the next section(s) to install the desired option(s).
4. Follow the above steps in reverse sequence to reassemble
the Bottom housing cover.
notes:
• E nsure the wiring route neatly as shown and arrange all
the wiring to avoid from being pinched when fitting the
bottom housing cover.
• W hen reassemble the Bottom housing cover to the
printer with ieee interface terminal, flip one of the clip
of the interface terminal as shown. Then fix the Bottom
housing cover while holding the other clip, pulling the
Bottom housing cover forward and downward.
screw x 3
clip
3