Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
It is recommended when placing your order to specify type of fuel "NG" or "LP", but if you need to
convert from NG to LP you need to do the following before connecting unit to gas supply:
1) Remove knobs.
2) Remove front control panel.
3) Loosen compression nut holding aluminum tube at the burner.
4) Unscrew fitting and #43 orifice from the mixing chamber.
5) Replace orifice with the 1.55mm colored orifice included with the hot plate.
6) Screw orifice and fitting back to bulkhead.
7) Reinstall front control panel and knobs back.
8) Reverse the plug in the pressure regulator. Marking on the plug while facing out should match
type of gas supplied.
CONVERTING TO LP
7
(End)
Publicité
Table des Matières
