Eagle Group CLHP-2-NG Instructions D'utilisation Et D'installation page 2

This appliance is guaranteed to be free from defects in material and workmanship under normal use and service and when installed in
accordance with factory recommendations.
The manufacturer's obligation under this warranty shall be to replace, at its option, any part deemed defective upon examination for a
period of one year from date of installation, but not to exceed two years from date of shipment. Installation date must be established by
return of warranty registration card or other means to the manufacturer's satisfaction.
All equipment returned to factory will be at owner's expense.
This warranty is void in the event of misuse, tampering, misapplication, or if incorrect voltage is applied.
This warranty is in lieu of all other warranties either expressed or implied and authorized by and the responsibility of Eagle Group.
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS
• BEFORE PLACING THIS APPLIANCE IN OPERATION, CONTACT YOUR LOCAL GAS SUPPLIER AS TO WHAT
INSTRUCTIONS ARE TO BE FOLLOWED IF YOU SMELL GAS. THE INSTRUCTIONS OBTAINED
SHOULD BE POSTED IN A PROMINENT LOCATION.
• THIS HOT PLATE MUST BE INSTALLED BY A TECHNICIAN QUALIFIED AND CERTIFIED OR LICENSED TO
INSTALL GAS-FIRED EQUIPMENT. INSTALLATION SHOULD COMPLY WITH ALL LOCAL CODES. A LICENSED
TECHNICIAN MUST PERFORM THE INITIAL STARTUP AND ADJUSTMENT OF THIS APPLIANCE.
•
This hot plate is designed as a heavy duty appliance and is not intended for residential use.
•
This gas hot plate was designed for countertop operation only.
•
Installation must conform to the National Fuel Gas Code #ANSI Z223.1-1996, the National Gas Installation Code #CAN/CGA-B149.1,
or the Propane Installation Code #CAN/CGA-B149.2 as applicable and in accordance with local codes.
•
Operators of this appliance must be familiar with the appliance use, limitation, and restrictions.
•
Do not submerge hot plate or burners in water. If burners get wet, they must be thoroughly dried before use.
•
Hot plate must be operated with the supplied legs properly installed.
NOTE: Appliance must be installed under a ventilation hood.
• DO NOT USE THE HOT PLATE AS A STOOL OR LADDER!
• DO NOT STAND OR SIT ON THE HOT PLATE!
• EXPOSED SURFACES CAN BE HOT TO THE TOUCH AND MAY CAUSE BURNS.
LIMITED W RR NTY
FOR YOUR S FETY
IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
IMPORT NT
C UTION
2
(continued on Page 3)