Installation; Connecting The Antenna; Installing The Remote Control Batteries - Magnasonic MCT2008 Guide D'utilisation

Instruction ManualManual

INSTALLATION

- Please read the safety instructions in this manual completely before installation.
- I n s t a l l y o u r TV in an area where direct sunlight will not fall upon the screen.
- S o f t , i n d i r e c t l i g h t i s b e s t f o r t e l e v i s i o n v i e w i n g .
- Allow enough space (at least 4 in.) between the TV and any walls or enclosures for proper ventilation.
- Optimum television viewing distance is 3-5 times the screen's size.
Auto-Degaussing
A color television can be easily affected by magnetism, which shows up as color distortion on the screen. If your TV is
a ffected by nearby magnetic components or appliances, turn it off for a few minutes. The built-in auto-degaussing
circuit will eliminate the magnetic interference.
Auto off when NO SIGNAL is received
The TV set will automatically enter into Standby mode when the following conditions are met.
1.TV is in antenna mode.
2.Current channel has no signal.
3.No key is pressed within 15 minutes.

Connecting the Antenna

VHF
U H F
or Cable
VHF
U H F
Notes:
1. It is recommended that a 75 ohm coaxial cable be used in order to
eliminate interference and noise which may occur due to nearby
radio
transmissions.
2 . The antenna cable should not be tied together with other wiring.
3. Set up a lightning rod and check it regularly when an outdoor
antenna
i s u s e d .

Installing the Remote Control Batteries

1. Remove the battery compartment lid.
2. Insert two AAA batteries (included). Make sure the positive (+) and
negative (-) polarities are correctly aligned.
3. Reattach the battery lid.
Notes:
1 . Alkaline batteries are recommended for longer life.
2 . Always replace both batteries at the same time.
3. Do not expose batteries to fire or break them open.
4 . To avoid battery leakage, remove batteries from the remote control
when it is not being used for a long period of time.
All manuals and user guides at all-guides.com
75-ohm coaxial cable (not supplied)
O R
300-ohm twin-lead cable (not supplied)
Antenna adapter
(not supplied)
O R
U/V mixer
(not supplied)
6
RF Input
(back of TV unit)