Transport; Functional Description - ABIKOR BINZEL ROBO WH Série Mode D'emploi

WH and WHPP
When equipped with the ROBO hose assembly, the Welding torch system WH/WHPP is not functioning.
For the initial assembly, additional components are required which depend on the welding task at hand.
They include the following:
• Torch neck (in the preferred size and geometry)
• Set-up parts and wearing parts (order separately)
Tab. 8 Components

4.1 Transport

Checking procedure
on receipt of goods
In case of damage
In case of complaints
Packaging for
returning the goods
Tab. 9 Transport
4.2 Storage

5 Functional Description

The hose assemblies for the Welding torch system WH/WHPP are available in
standard lengths or in customer-specific lengths. Option: Almost all robot
controls include the option of seam finding by means of a tactile sensor.
ABICOR BINZEL has the torch equipment required for this. The "Sensor"
option provides the gas nozzle potential at the machine side control line. Order
the set-up parts and parts subject to wear separately. Order data and part
numbers for the set-up and wearing parts can be found in the current
ABICOR BINZEL spare parts and wearing parts price lists. The contact for
consulting and ordering can be found in the Internet at www.binzel-abicor.com.
The components are carefully checked and packaged, however damage may
occur during shipping.
Check that the shipment is correct by referring to the shipping note.
Check that the shipment is correct by referring to the shipping note.
If the goods have been damaged during transport, contact the last carrier
immediately. Keep the packaging (for possible checks by the carrier).
Use the original packaging and the original packaging material.
If you have questions concerning the packaging and safety during shipment
please consult your supplier.
Physical storage conditions in a closed room:
 Tab. 2 General data on page EN-4
The functioning Welding torch system WH/WHPP comprises the following
components:
5 Functional Description
• Holder (required for fastening to the robot)
EN - 9