Out-Of-Balance Recovery Routine - Fisher-Price AquaSmart WL37T26KW2 Instructions D'installation

Changing pre-set options
30

Out-of-Balance recovery routine

When your AquaSmart™ is spinning it can sense if the
wash load is out-of-balance and will stop and re-try
spinning up to 3 times. If it still senses an unbalanced
load there are two options the machine can take.
Automatic Recovery option
Your AquaSmart™ will try to automatically correct the
out-of-balance load. It will fill with water and agitate
to redistribute the load before trying to spin up again.
Machine Stops option
Your AquaSmart™ will stop, give a short burst of beeps
every 5 seconds, and the spin speed lights will flash.
You must redistribute the load more evenly yourself.
(Use this option if you wish to conserve water).
Your washer arrived with the 'Machine Stops'
option set.
Enter Options Adjustment mode (refer to page 28).
1
Select SOAK to program your AquaSmart™ to
2
automatically recover.
Press POWER to save your selection.
3
Reset Back to Factory Settings
If you would like to reset all settings back to those
that were set when your AquaSmart™ left the factory
you have the option of selecting RESET DEFAULTS.
Enter Option Adjust Mode (page 28).
1
Press and hold the START /PAUSE button until you
2
hear one quick beep. This indicates that all settings
have been returned to the factory default settings.
All manuals and user guides at all-guides.com
SOAK
light on = automatic recovery
SOAK
light off =machine stops
Fig.21 Adjusting Out-of-Balance
recovery routine
Fig.22 Resetting factory defaults