Connecting A Vcr - Samsung PN42A450P1D Guide De Configuration Rapide

Connecting a VCR

Connecting to Video
VCR Rear Panel
Audio Cable
(Not supplied)
Video Cable (Not supplied)
Antenna Cable (Not supplied)
➢ When connecting a VCR, match the color of the connection terminal to the cable.
➢
If you have a "mono" (non-stereo) VCR, use a Y-connector (not supplied) to hook up to the right and left audio input jacks of the
TV. If your VCR is stereo, you must connect two cables.
➢
Each VCR has a different back panel configuration.
➢ When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does not match the color of the video cable (Yellow).
Connecting to S-Video
VCR Rear Panel
Antenna Cable (Not supplied)

2
Audio Cable (Not supplied)
S-Video Cable (Not supplied)
➢ When connecting a VCR, match the color of the connection terminal to the cable.
➢
Each VCR has a different back panel configuration
TV Rear Panel
2 
TV Rear Panel
English - 5
1
2
TV Side Panel
3
4
5
6
1
TV Side Panel
2
3
4
Unplug the cable or antenna from
the back of the TV.
Connect the cable or antenna to the
ANT IN terminal on the back of the
VCR.
Connect an Antenna Cable between
the ANT OUT terminal on the VCR
and the ANT IN terminal on the TV.
Connect a Video Cable between the
VIDEO OUT jack on the VCR and
the AV IN 1 [Y/VIDEO] or AV IN 2
[VIDEO] jack on the TV.
Connect Audio cables between the
AV IN 1 [R-AUDIO-L] jacks on the
TV and the AUDIO OUT jacks on
the VCR.
Press the SOURCE button on the
remote control until you see the VCR
signal (see "To Select the Source"
on page 10).
To begin, follow steps 1–3 in the
previous section to connect the
antenna or cable to your VCR and
your TV.
Connect a S-Video cable between
the [S-VIDEO] jack on the TV and
the S-VIDEO OUT jack on the VCR.
Connect Audio cables between the
AV IN 2 [R-AUDIO-L] jacks on the
TV and the AUDIO OUT jacks on
the VCR.
Press the SOURCE button on the
remote control until you see the VCR
signal (see "To Select the Source"
on page 10).