Technical Data; Before Starting The Equipment; Selecting The Mode Of Operation - Riwall PRO REBV 3000E Notice Originale

4. Technical data

AC motor
Output
Protection class
Air velocity
Suction rate
Volume of debris bag
Sound power level L
WA
Sound pressure level L
pA
Vibration a
hv
Weight

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating
plate are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Assembling the suction tube (Fig. 2-3)
- Press and hold the lock (Fig. 2).
- Pull out the suction tube to its full length, as
shown in Fig. 3.
- You can then release the lock.
5.2 Fitting the debris bag (Fig. 4)
Hang the bag into the motor housing.
Then slip the debris bag (Fig. 4/Item 7) over the
port on the motor housing.
Make sure that there is an audible click when
they engage.
Start up the tool only after it is fully assembled.
Always inspect the tool power cord for damage
before starting up. The tool may only be used if
the cord is in flawless condition.
6. Operation
6.1 Sizing the strap (Fig. 1)
Size the length of the carrying strap (4) so that
230-240 V ~ 50 Hz
3000 W
II/
270km/h
3
13,5 m
/min
ca. 45 l
98,1 dB (A), K=2 dB (A)
86,6 dB (A) K=3 dB (A)
2
0,815 m/s K=1,5 m/s2
3,3 kg
the vacuum tube just clears the ground. The
guide rollers (9) at the bottom end of the suction
tube will help you to maneuver the suction tube
on the ground.
6.2 Connecting the tool to the power supply
and switching on (Fig. 5, 6)
The tool can be plugged into any socket-outlet
(with 230 V AC) that is equipped with a 10A fuse
or higher.
The socket-outlet has to be safeguarded by
an earthleakage circuit breaker (e.l.c.b.). The
operating current must not exceed 30 mA.
• Insert the tool plug into the power cord
coupling (extension).
• Secure the power cord with the sleeve provided
on the tool as shown.
• To switch on, press and hold the ON/OFF switch
(Fig. 6/Item 5).
• To switch off, let go of the ON/OFF switch (Fig.
6/item 5).

6.3 Selecting the mode of operation

6.3.1 Suctioning (Fig. 7)
• Turn the lever (Fig. 7/Item 8) to position F. You
can do this both when the device is at a standstill
and while it is running.
6.3.2 Blowing (Fig. 7)
13