Explanation Of The Application Range; Mounting Instructions - Uponor Mini2 Mode D'emploi

made by

4.2 Explanation of the application range

The hand guided pressing tool is to mount fi ttings on multi Layer. The unit is not supposed to be restrained in a vise.
It is not allowed to use the tool in a stationary application.
The tool is not designed for continued pressing operations. After a sequence of approximately 50 completed com-
pressions you have to make a break of 15 min. to give the tool time to cool down.
Attention
Too intensive use can cause heat damages for the tool
Attention
During the operation of built-in electric motors sparks can occur which might ignite highly infl ammable or
explosive liquids and materials
Attention
Electric tools must not be operated in pouring rain or under water.

4.3 Mounting instructions

Please reference the assembly manual of the systems supplier before mounting the fi ttings on the pipes. In order to
safeguard a proper pressing and to guaranty a safe and reliable handling the machine must only be operated with
released system jaws. If the markings on the tool and pressing jaw do not match respectively if there are no assembly
instructions the user has to contact the provider of the system to request a compatibility statement.
Attention
Do not use bent or damaged pressing jaws.
4.4 Service and maintenance instruction
The reliable performance of the tool is dependent on careful treatment and service. This represents an important
condition to safeguard a lasting connection. To safeguard this the tool have to be maintained and serviced regularly.
GB
6
All manuals and user guides at all-guides.com
Instruction Manual
Mini
2
HE.15874 - Mini² - 01/2015