Light-N-Carry LNC312 Manuel D'utilisation page 5

CHARGING
NOTE: CHARGE THE TORCH LIGHT IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE, AND AT LEAST
EVERY 3 MONTHS WHEN NOT IN USE. Failure to do this
will reduce the battery's useful life.
Pull aluminum housing sleeve to expose microUSB charge port.
Connect the microUSB end of the charging cable to the
microUSB port on the torch light. Connect the USB end of the
charging cable to the USB port of a common 5V AC charger.
The Charging Status LED will illuminate red to indicate unit
is charging. To reach full charge, continue charging until the
Charge Status LED turns green.
Charging will take approximately 1.5 hours, depending on the
unit's state of charge at the start of the cycle.
The charging process is fully automatic and the light can remain
connected to the charger indefinitely without adverse conse-
quences.
5