Program Setting; Maintenance - JARDIBRIC KPBRU20 Notice

1
/

PROGRAM SETTING :

1. AUTOMATIC OPERATION :
Set the ON (misting time) and OFF (pause time) dial buttons to the desired values. The misting
program is defined and runs immediately, automatically, according to the programmed values.
You can change the program at any time by turning the dial buttons on new values.
2
/

MAINTENANCE :

At the end of each use, the mist tube must be purged.
!
There should be no stagnant water left in the mist tube, this can obstruct the mist nozzles
and the system may no longer work properly during next uses.
1. Make sure you have
properly shut the water
supply and that the 2 ON
and OFF dial buttons of
the programming pump
are set on OFF.
E
Replace the anti-lime filter every 4,000 liters ( 440 hours) (as
indicated on the filter label)
2. MANUAL OPERATION :
To start misting immediately for an indefinite period :
set the ON dial button to Man. Then on OFF to stop the
misting.
To resume the programmed cycle, position the ON dial
button on the desired value.
3. OFF MODE :
To stop a program in progress or to cut off the misting, set
the ON and OFF dial buttons to OFF.
To reactivate it, you must reprogram your device.
L
2. To purge the system
slightly unscrew the end of
the end plug nozzle so that
any water still present can
come out of the hose.
.
L
3. Once finished, screw the
end of the nozzle back on.
EN
11