Publicité
Les langues disponibles
Les langues disponibles
FH 5038
Overheating safety device
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the
power as soon as the heating elements become too hot. If this should happen:
First ensure that it was not the thermostat which has switched off the heater. Set the thermostat to
maximum position. If the heater does not switch on, the safety device has been activated.
Remove the mains plug from the wall socket.
-
Let the heater cool down for 30 minutes.
-
Check if the heater had been placed correctly.
-
Check if anything is obstructing the air flow.
-
If necessary, clean the grilles with a vacuum cleaner.
-
Replace the plug into the wall socket and switch the heater on again.
-
If the safety device again switches off the heater:
Remove the mains plug from the wall socket.
-
Have the heater inspected by a Service Centre or by your dealer.
-
CLEANING
We recommend that you clean your heater at least twice a year to remove accumulated dust and dirt.
Set the selector switch to position
-
Wait for the heater to cool down sufficiently.
You may clean the outside of the heater with a damp cloth or brush. Do not use water or allow
-
water to come into the appliance. Do not use any abrasive and caustic cleaning agents!
Never touch the heater in water! Danger to life!
-
Clean the air inlet and outlet grilles regularly with a vacuum cleaner, using the brush attachment.
-
STORAGE
Keep the original box in which the heater was packed to store it during the warmer months when it is
not in use. Clean the heater according to the instructions under Cleaning.
Pack the heater in the original box and store it in a cool, dry place.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact
on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct
disposal of their old appliance.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2014/30/ EU and the
requirements of the EMC directive 2014/35/ EU
to switch off. Remove the mains plug from the wall socket.
15
Publicité
