Assembly - APEXRA APHP-12-2 Manuel D'entretien, D'installation Et D'utilisation

ASSEMBLY

1. Screw legs into the
2. Level the unit by
move the unit.
CAUTION
DO NOT use an open flame
Check all gas piping for leaks
A qualified installer who
Installation must conform
Z223.1/NFPA 54, Liquefied
B149.2 as applicable and
The appliance and its individual
during any pressure testing
The appliance must be isolated
pressure testing of the gas
The installer must include
•
Pipe thread sealing compound
•
• Verify that the product
Adjust pilot if necessary.
•
Adjust main burner(s)
•
Adjust main burner
•
permanently fastened nuts on the four corners of
turning the adjustment screw
to check for leaks.
with a soap and water
thoroughly reads, understands
with local codes, or in the absence
Petroleum Gas Code ANSIINFPA 58, CSA-B149.1, or
in accordance with local
shutoff valve (to
of that system at test pressures
from the gas supply
supply piping system at
a manual valve
must be resistant
regulator and orifice
if necessary.
air shutter if necessary.
at the bottom of each
solution before operating
and follows these instructions
of local codes,
codes.
be supplied by user) must
in excess of ½ psi
piping system by closing
test pressures equal to or less than ½
to shut off the fuel supply
to the action of liquefied
match gas type (natural
Page 8
the unit and tighten by hand.
leg. Do not slide unit with legs mounted;
unit.
should perform
with the National Fuel Gas Code, ANSI
the Propane Installation Code, CSA-
be disconnected from the gas
(3.5 kPa).
its individual manual shut-off valve during any
psi (3.5 kPa).
into the appliance.
petroleum gases.
gas or LPG-propane).
lift to
installation.
supply piping system