Troubleshooting; Technical Data - Hamron 608210 Traduction Des Instructions D'origine

7

Troubleshooting

Problem
The product does not start.
The product does not charge the
battery.
The product does not charge the
battery, the error code "LO" shows in
the display and a warning signal is
heard.
8

Technical data

Technical data
Rated voltage
Output voltage
Charging current
Display
Alarm function/warning signal
23
Cause
The power plug is not connected to a
power source.
The power cord is damaged or
defective.
There is bad connection between the
product and the battery.
The clips cables are damaged or
defective.
The voltage in the battery is too low.
230 V ~ 50Hz
12 V (DC)
1/3/5/10 A
Yes
Yes
Action
Make sure that the power plug is fully
connected to a power source.
Speak to an authorized service center.
Do a check of all cables and
connections. Clean the battery
terminals if it is necessary.
Speak to an authorized service center.
Only charge 12 V batteries.
2022_001