To Do Before You Operate The Product; To Connect The Product To A Battery; To Charge A Battery - Hamron 608210 Traduction Des Instructions D'origine

● Make sure that the clamps cannot short-circuit.
● Make sure that you connect the clamps to the
correct terminal on the battery.
● Only operate the product in a well-ventilated
area. Batteries emit explosive gas when they
are in use and when they are charging.
● Make sure that you follow the safety
instructions for vehicles and other machines
that are near the product when you operate the
product. Risk of explosion.
● Make sure that the product is put at least 50
cm above floor level when you operate the
product in a closed environment.
● Keep children and bystanders at a safe
distance from the product when the product is
in operation.
● Do not attempt to open the product. Risk of
electric shock.
● Do not disassemble the product. The
manufacturer cannot accept liability for any
damage or injury that is a result of
unauthorized disassembly.
● Keep the product in a dry and closed storage,
away from children, when the product is not in
operation.
● Make sure that all switches are in the off
position when the product is not in operation.
● Make sure that the power plug is disconnected
when the product is not in operation.
● Make sure that all switches are in the OFF
position before you clean or do maintenance
on the product.
● Clean the product regularly.
3 Operation
3.1 To do before you operate the
product
Caution! Always refer to the operator's manual for the
battery before you charge the battery.
● If you are charging a battery in a vehicle, make sure that
it is possible to use an auxiliary starter.
Caution! The computer system in the vehicle can
become damaged if it is not compatible with an auxiliary
starter. Refer to the operator's manual of the vehicle.
21
● Make sure that the area is well-ventilated.
● Make sure that the electrolyte level in the battery cells is
correct. Fill with distilled water if it is necessary. Refer to
the operator's manual of the battery for instructions.
● Make sure that the battery is a 12 V battery. Refer to the
operator's manual for the battery or the vehicle if you are
not sure.
● Clean the battery terminals and make sure that the is no
corrosion.
Warning! Use safety glasses.
3.2 To connect the product to a
battery
Caution! Risk of short-circuit. Make sure that the clips
cannot touch each other.
Caution! Put the product as far away as possible from
the battery you connect it to. Do not put the product directly
above the battery that you charge. Gases from the battery
can cause damage to the product.
1
Connect the charger to a power source. Symbols for
voltage, clips, and battery level shows in the display.
2
Connect the red positive (+) clip to the positive (+)
terminal on the battery.
3
Connect the black negative (-) clip to the negative (-)
terminal on the battery.
Note! If the clips are connected to the incorrect terminal, a
warning sound will be heard. The display shows a warning
symbol and the error code "Err". The warning sound will stop
when you disconnect the clips from the terminals.
4
Disconnect the product from the battery in the
opposite sequence.
Warning! Risk of electric shock. Always disconnect
the black negative (-) clip first.

3.3 To charge a battery

Caution! Risk of short-circuit. Make sure that the clips
cannot touch each other.
Caution! If you are charging a battery in a vehicle,
make sure that it is possible to use a auxiliary starter. The
computer system in the vehicle can become damaged if
2022_001