Before Use - aidapt VG820 Notice D'utilisation Et D'entretien

INTRODUCTION
Thank you for deciding to purchase the Birling Back Rest from Aidapt. The Birling
Back Rest is manufactured from the finest material and components available,
when installed and used correctly it is designed to give many years of reliable
trouble-free service.
The Birling Back Rest can be used on single, double, queen and king size beds.
N.B. This equipment must be installed by a competent person and a risk
assessment may be needed as to the suitability of the chair for the particular
user.
108 kg (17 st.) weight limit.
Do not exceed the weight limit stated – doing so could put the user at risk.

BEFORE USE

Carefully remove all packaging. Avoid using any knives of other sharp instruments
as this may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault,
do not use your product, but contact your supplier for support.
N.B. Part of the product packaging is plastic, please take care when handling
and keep the packaging well away from children and babies to avoid the
danger of suffocation.
Please dispose of all packaging carefully.
ASSEMBLY AND INSTRUCTION
1. Place the back rest onto the bed squarely with the blue fabric covered
support section facing upwards and the small padded head rest at the top
of the bed.
2. Raise the blue fabric covered support section of the back rest to the
required height.
3. Insert the hinged holding bar on the back of the support section into one
of the sets of plastic hook stays on the base of the product.
4. Ensure that the bar is fully located both of the hook stays before use.
Usage and Maintenance Instructions
2
Ver. 3 07/2012 (1263)