INSIDO 89980050/02 Mode D'emploi page 13

In order to achieve the best performance, empty the dust cup and clean the dust cup filter after each use.
1. Press the dust cup release button (C) to remove the container from the main unit.
2. Press down the locking clip (D) on low end of the dust cup to empty dust from the container.
3. Detach the upper part from the dust cup. Gently pull the dust cup filter (A) and dust filter (B) out of the dust
cup. Rinse them in warm water, and then air dry completely before placing them back in the dust cup.
Important Note: DO NOT use a washing machine to clean the dust cup filter. Do not use a hair dryer to dry it.
AIR DRY ONLY.
4. Put the dust cup filter and dust filter carefully into the dust cup. Never operate the appliance without the
filters in place.
5. Attach the dust cup to the main body of the unit.
Note: It is recommended that the dust cup filter be replaced every three months (depending on usage) to ensure
peak performance of the unit.
TROUBLESHOOTING
PROBLEM
Appliance does not operate
Appliance does not pick up or
suction power is weak
Dust escaping from appliance
TECHNICAL DATA
Operating voltage: 220-240V ~ 50/60Hz
Power consumption: 600W
POSSIBLE REASON
No power in electrical outlet.
1. Dust cup is full.
2. Dust cup filter needs cleaning
or replacement.
1. Dust cup is full.
2. Dust cup filter is not installed
correctly.
- 12 -
SOLUTION
Check fuse or breaker. Replace
fuse/reset breaker.
1. Empty dust cup container.
2. Remove dust cup filter and check
for object(s) in air duct and remove.
Clean or replace dust cup filter.
1. Empty dust cup container.
2. Check and install the dust cup filter
correctly.